● Six estimators · Unit-aware · Private

Home material
estimator

Estimate paint, flooring, tiles, wallpaper, concrete and decking quantities before you shop or request quotes.

✓ No sign-up✓ Browser-based✓ Instant results
Project inputs

Paint estimate

Typical starting point: 5–10% for simple layouts and 10–15% for cuts, patterns or breakage. Your product and installer may require more.

Calculated on this deviceYour dimensions and estimates are not submitted to or stored by Utilaroo.

Estimate, then verify

Turn dimensions into a more useful shopping quantity

The estimator separates the measured requirement, waste allowance and purchasing unit, making it easier to compare products and discuss the job with a supplier or installer.

01

Measure consistently

Use the same measurement system for every field and measure each project area at more than one point where walls or floors may be uneven.

02

Check the product

Coverage, pack size, bag yield, tile batch and board dimensions must come from the specific product you plan to buy.

03

Allow for the layout

Patterns, diagonal cuts, corners, breakage and future repairs can justify a larger allowance than a simple rectangular installation.

Questions answered

Home material estimator FAQ

Are these quantities suitable for ordering materials?

They are planning estimates. Confirm all measurements, coverage information and waste requirements with the selected product, supplier or qualified installer before ordering.

What waste allowance should I use?

Simple layouts may need 5–10%. Tiles, flooring, wallpaper and decking with patterns or many cuts can require 10–15% or more. Follow the manufacturer’s and installer’s guidance.

Does the concrete estimate cover structural design?

No. It estimates material volume only. Structural slabs, footings, reinforcement, drainage and load requirements need appropriate plans and qualified advice.

Does Utilaroo save my project dimensions?

No. The calculations run locally in your browser and the dimensions are not submitted to Utilaroo.

Method, example and limitations

Understand the result before using it

Use the estimator for an initial shopping quantity for paint, flooring, tiles, wallpaper, concrete or decking. It converts dimensions into area, volume or linear coverage, applies the waste allowance you choose and rounds to whole packs where required.

01 · Calculation method

What the tool does

Each mode exposes its basis: wall area minus openings for paint, floor area for packs and tiles, wall width divided by roll coverage for wallpaper, length × width × depth for concrete, and deck width divided by board-plus-gap spacing for decking. Product coverage and pack size remain user inputs.

02 · Worked example

Paint a 5 m × 4 m room, 2.4 m high

  1. Wall area is the 18 m perimeter × 2.4 m = 43.2 m².
  2. After 5.2 m² of openings, two coats require 76 m² of coverage.
  3. At 12 m²/L plus 10% waste, allow about 7 litres before can-size rounding.

How to read it: The estimate is only as reliable as the measurements and product data. Surface condition, pattern matching, cuts, board layout, coat count and supplier pack rules can dominate the waste allowance.

Assumptions used
  • All dimensions describe the same finished geometry.
  • Coverage figures come from the actual product data sheet.
  • Waste is applied to the calculated requirement before pack rounding.
Common mistakes to avoid
  • Using nominal room dimensions without measuring alcoves and openings.
  • Applying a generic paint-coverage figure to a porous surface.
  • Ordering structural concrete or decking solely from a consumer estimate.